How to Diagnose Wheel Speed Sensor Air Gap Problems


A wheel speed sensor code does not always indicate a faulty sensor. Wear inside the wheel bearing hub unit can also cause problems with the anti-lock braking system (ABS). When a hub develops play, the air gap between the wheel speed sensor and the reluctor or encoder ring can change. This can distort the signal the ABS system uses to calculate wheel speed.
How Wheel Speed Sensor Signals Are Affected
There are two basic types of wheel speed sensors: passive and active.
Passive sensors generate an AC voltage that changes with wheel speed. Active sensors produce a switched signal whose frequency changes as the wheel rotates. Both types depend on maintaining the correct air gap between the sensor and the reluctor or encoder ring.
Excessive end play or runout caused by hub bearing wear can shift the hub’s rotational axis. As the wheel turns, the changing air gap can weaken or distort the wheel speed signal. Passive sensors can also collect metallic debris on their magnetic tips. Resistance in wiring or connectors can further reduce signal strength.
Hub Bearing Wear and ABS Diagnostic Codes
Many late-model hub units use active sensors with magnetic encoder rings built into the seal. These systems are also sensitive to changes in the air gap.
If the sensor moves too far from the encoder ring, the signal can weaken or disappear. The ABS hydraulic control unit may interpret this as an inaccurate wheel speed reading.
This can trigger diagnostic trouble codes (DTCs) described as “erratic,” “performance” or “implausible.”
When diagnosing a wheel speed sensor code, technicians should inspect more than the sensor itself. Check the wiring and electrical circuit for problems. Also inspect the hub bearing and the air gap between the sensor and reluctor or encoder ring.
Don’t forget to follow us on Instagram and Facebook and subscribe to our YouTube channel for more tire, service and shop operations videos.