New Biobattery Design Takes Cues From the Gut


By Kyle Proffitt
November 20, 2026 | Batteries created out of living cells or enzymes, feeding off of excess sugars or other organic molecules, and giving off electrical energy—this is the promise of biobatteries. Microbial fuel cells are one attractive implementation, typically created with simple, planar arrangements—stacked layers of bacteria, separator, and cathode—with little thought to the well-being of the living microorganisms required to make the system work. Researchers at the State University of New York, Binghamton have taken steps to address this oversight by creating topology with 3-dimensional finger-like projections inspired by the villi seen in the small intestine.
“We stopped treating the electrode as a flat surface that bacteria sit on and built it as a place for them to live,” corresponding author Seokheun “Sean” Choi told Battery Power Online via email. The benefits exceed expectations, too: “When many villi share one patch, they help each other, so power density rises to about 300 µW cm⁻³,” he said. The research was published September in Small (doi: 10.1002/smll.76091).
Biobattery Concept
Biobatteries are an attractive idea for harvesting small amounts of energy from living things, either directly or indirectly. Concepts include enzymatic chips that oxidize glucose, triboelectric generators that convert motion to energy, and Choi’s favored approach: microbial fuel cells that can eat a range of small molecules and export electric current as a byproduct of their metabolism. Battery Power Online previously spoke with Choi in 2022 about some of his designs and ideas. At the time, he was using Shewanella oneidensis bacteria in paper-based batteries that could be activated by spit or other fluids. These devices were created primarily for single use, such as in point-of-care testing, shipment tracking, etc.
Although the energy produced by a single battery such as these is in the microwatt range, it works anywhere there is fuel for bacterial survival, and, Choi says, “that fuel is everywhere: in wastewater, in sweat, in the gut.” There’s an untapped supply of seemingly limitless energy available for harvest.
Choi has since moved away from S. oneidensis. “When we talked in 2022, I told you the biggest issue was getting reliable and robust performance without toxicity problems,” he said. “We moved to Bacillus subtilis spores; this bacterium is widely regarded as safe, and its spores can sit dormant for a long time and wake up only when nutrients arrive. That gave us shelf life and on-demand start-up, which the earlier paper devices did not really have.” As far as its general safety, you’ll see B. subtilis included in many over-the-counter probiotic formulations.
Gut Feeling
With an interest in making the bacterial environment more hospitable, Choi looked to the digestive tract. In the small intestine, a symbiotic relationship exists between host and colonizers; finger-like villi coated with mucus create an attractive home and encourage microbial residency. The bacteria give back by aiding digestion, producing vitamins the host can’t generate on its own, crowding out would-be pathogens, and training the immune system to discern friend from foe.
Choi’s group decided to manufacture the anode of their microbial fuel cells to mimic this architecture. “The anode is a soft conductive hydrogel shaped into finger-like villi, with dormant bacterial spores stored inside,” Choi said.
There are a few significant differences from the biological template. They are not reproducing a mucus layer, yet. The bacteria are actually embedded within a hydrogel containing poly(3,4-ethylenedioxythiophene) (PEDOT), polystyrene sulfonate (PSS), reduced graphene oxide (rGO), and polyvinyl alcohol (PVA), whereas in the small intestine, bacteria typically reside in the mucus surrounding villi. The scale is also significantly different. “Our villi are millimeters in size, while real ones are well under a millimeter,” Choi said.
Battery Assembly and Function
To create their batteries, the bacteria/PEDOT/PSS/rGO mixture was poured into a prepared mold to create villi, and three freeze-thaw -80 °C to 20 °C cycles were performed, which concentrates PVA polymers, promoting their hydrogen bonding, and physically crosslinks the hydrogel. An ion exchange membrane was prepared based on Nafion, phosphoric acid, and PVA, and was conformally molded to the underside of villi with another freeze-thaw cycle. Finally, the cathode—carbon cloth with embedded manganese dioxide, titanium dioxide, silver oxide, and carbon nanotubes—was adhered with a PVA layer and one more freeze-thaw cycle to complete the stack.
Unlike S. oneidensis, B. subtilis are not exoelectrogenic; they do not transfer electrical energy directly to external locations. However, B. subtilis has been recognized as an electroactive organism that can indirectly transfer electrons through soluble metabolites, cell-surface-associated redox components, or other extracellular biofilm-associated substances.
As to how the battery actually works, in a standard example, during aerobic respiration, the complete oxidation of glucose is coupled with proton pumping across a membrane, driving ATP synthesis, with harvested electrons dumped onto oxygen. However, in a low-oxygen environment, B. subtilis likely dumps these electrons onto soluble redox-active molecules, such as flavins, which then diffuse and transfer electrons to the conductive hydrogel. The freed electrons travel through an external wire, where they can be used to perform work, and then reduce MnO2 and Ag2O in the cathode. At the same time, protons and other cations freed during glucose and other food molecule oxidation pass through the PVA/Nafion membrane to reach the cathode, balancing charge. Unlike a lithium-ion battery, there is no recharging.
Villi Are Better
Because this design increases the surface area, “the shape alone gave about eight times more power per volume than a flat version made of the same materials,” Choi said. The paper reports an increase from about 8 to 66 µW/cm3 by adding villi, but packing the villi together produced over 300 µW/cm3. “We now have evidence that many small units placed together can do better than the sum of their parts,” he said. “The cooperative effect surprised us; wiring separate units together did not improve power per unit, but putting villi side by side in one patch did.”
The increased power that can be generated with their 3-dimensional design can make significant differences in device utility. “A low-power sensor that needs around 100 µW would require about 12 cm³ of the flat design, about 1.5 cm³ of the single-villus design, and about 0.3 cm³ of the integrated patch,” Choi said. “That is the difference between an awkward block and a small patch.” However, “for context, we are still in the microwatt range,” Choi said. “Enzymatic fuel cells can give more power but usually do not last long; microbial cells built with stronger electricity-producing species can also beat us on raw power.”
Smaller Villi Are Even Better
The researchers performed several experiments comparing how villi height, diameter, and packing would influence power output, and there is evidence that continued pursuit of more scaled-down biological mimics will yield further improvement. “The smallest villi we made (1.5 mm radius, 3 mm tall) gave the highest power density, about 119 µW cm⁻³,” Choi explained. “Thinner villi have more surface per volume and shorter paths for nutrients to reach the cells,” he added. However, there are practical hurdles to further miniaturization. “We mold the hydrogel, and very thin, soft pillars are hard to release without breaking, and they shrink during curing,” Choi said. “Each smaller villus also makes less power, so you need many of them packed densely and wired well.”
Sewage Sensors
To demonstrate how these devices could be used, the researchers designed a patch and placed it in a simulated wastewater pipe continuously supplied with nutritious media. In this arrangement, the battery produced 0.75 V, sufficient to power an LED bulb, and ran continuously for 14 hours. “Self-powered monitoring in places where nobody wants to change batteries is the realistic first application,” Choi said, envisioning “a soft patch inside a pipe that powers itself from the wastewater and reports what is flowing past it.”
The group performed one more demonstration with a 3 × 3 array—9 individual villi—showing that one can not only harvest the cumulative energy from several villi but also achieve spatial detection. “Each villus responds to its own local nutrient supply, so a 3 × 3 array gives a voltage map of where the fluid has reached and how concentrated it is,” Choi said. “In a pipe network, that could show where a contaminant is entering, or whether flow is uneven, without any external power or sensors.”
Choi’s lab has also worked extensively on ingestible and skin-adherent devices, and lessons with villi could translate to better power generation in these implementations, with some modifications. “For skin or ingestible use, we would need shorter villi and a thinner overall stack,” Choi said. “The good news is that the shorter villi were the most power-dense in our tests, so shrinking works with us, not against us. What carries over to those applications is the principle, and the dimensions would have to be redesigned for each one.”
Challenges
One factor that has not yet been thoroughly addressed is device longevity, as the cathode metals are a limiting reagent. “A solid oxidant in the cathode is consumed, so the lifetime is finite,” Choi explained. The group intentionally chose this design, however, because of the low or unreliable oxygen supply in a wastewater pipe. To extend device lifetime, Choi proposes a few solutions. “Sewer pipes are often only partly full, so a cathode could use air when it is available and rely on the manganese oxide when it is not.” Additionally, “reduced manganese can be re-oxidized by oxygen, so periodic air exposure could partly recharge it.” For now, he says, “a replaceable cathode layer is the simplest engineering answer.”
Thus far, actual wastewater has not been used, and there are likely to be challenges. “Real wastewater changes hour to hour, carries solids that can foul the surface, contains native microbes that will compete with ours, and may contain compounds that inhibit them,” Choi said. “We also need to confirm that it triggers spore germination reliably … long-term testing in real streams is the next step.”
Continued Vision
Choi has a few ideas for further refinement, and some of that involves leaning into biomimicry. “In our next design, we want to place the spores in the outer shell of each villus,” he said. He explained previously that only the gut architecture has been pursued thus far, and more emphasis must be given to understanding the physiological and chemical makeup that maintain microbial viability.
To pursue higher power, Choi highlighted the improved energy density with smaller villi. “That tells us how to scale: build denser patches, the way the intestine does,” he said. To make this a practical reality, he cited direct 3D printing as the most likely route, but he was cautious with predictions. “I would not promise a number, because the gain will not scale simply with size,” he said.
Asked about the vision he shared in 2022—a future of tiny, self-powered, self-mobilizing, self-repairing, and inter-communicating sensors—Choi said that “the vision has not changed, and I believe in it more now; what has changed is that it is less of a dream and more of an engineering plan.” Pointing to the improved power output with cooperative villi, he added that “the idea of many small power sources working as a network is stronger now than it was four years ago.”
“I no longer think of these devices as just batteries. In this work, the same patch generates power and senses its surroundings. That is closer to the self-sustaining small systems we discussed.”